Description

Imagine you could fasten sheet metal....
Without the fumes, sparks and damage of spot welding.
Without the predrilled holes and hassles of riveting...and...all at a lower cost!
Join the thousands of others who have already started clinching.
surelokii
norlok-close-up
Base price
Description

What are the advantages of clinching?

Fast and consistent joint quality
With fast cycle times and unsurpassed consistency, production is increased.

No rivets, bolts, fasteners, heat or adhesives
The least expensive way to fasten material.

No fumes, heat or electrical hookups
Clinching allows for a clean and safe working environment.

Little or no damage to material
No rework as there is no heat to burn paint or galvanized finishes.

Join dissimilar material
Fasten different materials and thickness together with the same machine.

Simple adjustments and very little maintenance
Save on downtime and maintenance.

Portable and versatile
Norlok machines can be built in portable versions or custom designed to fit your needs.

How does clinching work?

The Clinchlok joint is formed when the upper tooling squeezes the two ply of material joined between the punch and die.
The amount of squeeze is very important to the strength of the clinchlok joint and to the life expectancy of the punch and die.
Note that the die is of a very special design that allows the Clinchlok to "mushroom".
The punch is also a special design and unlike a normal punch the edge of the punch is not sharp, but is rounded.
This is known as the punch tip radius. Neither the punch or die can be sharpened.

If different thicknesses are to be joined, the best results occur when the thicker material is on the upper (punch) side of the two ply.
The thicker material should not be more than twice the thickness of the thinner material.
The combined thickness of the two ply should not exceed the combined maximum thickness recommended for the die.
Other materials can be joined with the SURELOK II as long as they are not harder than commercial quality mild steel.
In most cases both ply should be of the same hardness.
If a different hardness is used for each ply (not recommended) the harder material should be on the upper (punch side) if possible.

Our business was able to find the ideal machine tools for our shop. Productivity, quality, efficiency have been raised across the board.